Home > Quicken Error > Quicken Error Code 7045

Quicken Error Code 7045

Contents

These task return error codes, which do not mean much to the user. Insert %2 (Volume Serial Number: %3) into drive %1. 36 Too many files opened for sharing. 38 Reached the end of the file. 39 The disk is full. 50 The request The table below describes these Error codes Causes Windows does not return error messages all the time. HiTek Software Automation Experts Automize Autokrypt AbleFtp JaSFtp JaBack | Home | Products | Downloads | Purchase | Support Improve your productivity and save time. have a peek at these guys

Verify that the network path is correct and the destination computer is not busy or turned off. The file to be replaced has retained its original name. 1177 Unable to move the replacement file to the file to be replaced. The caller now needs to enumerate the files to find the changes. 1051 A stop control has been sent to a service that other running services are dependent on. 1052 The Title Windows System Error Codes (exit codes) Date Updated 03/24/2006 Versions affected Automize 4.x+ OS affected Windows Description The Command and WinCommand task sometimes do not return any error messages, when

Quicken Error Codes

The recovery was successful. 1015 The registry is corrupted. The registry could not read in, or write out, or flush, one of the files that contain the system's image of the registry. 1017 The system has attempted to load or Code Description 0 The operation completed successfully. 1 Incorrect function. 2 The system cannot find the file specified. 3 The system cannot find the path specified. 4 The system cannot open

The serial driver will unload. 1119 Unable to open a device that was sharing an interrupt request (IRQ) with other devices. Therefore, the service control manager cannot take action if this service's process terminates unexpectedly. 1082 No recovery program has been configured for this service. 1083 The executable program that this service If Windows still cannot find the network path, contact your network administrator. 52 You were not connected because a duplicate name exists on the network. Quicken Unknown Error Occurred At least one other device that uses that IRQ was already opened. 1120 A serial I/O operation was completed by another write to the serial port. (The IOCTL_SERIAL_XOFF_COUNTER reached zero.) 1121

Go to System in the Control Panel to change the computer name and try again. 53 The network path was not found. 54 The network is busy. 55 The specified network Quicken Com Error Crash Please make sure that all required file system drivers are loaded and that the volume is not corrupted. 1006 The volume for a file has been externally altered so that the The structure of one of the files containing registry data is corrupted, or the system's memory image of the file is corrupted, or the file could not be recovered because the The file to be replaced has been renamed using the backup name. 1178 The volume change journal is being deleted. 1179 The volume change journal is not active. 1180 A file